14 Inch 72 Tooth Industrial Level Steel and Ferrous Metal Saw Blade with 1 Inch Arbor

Great Product! Much better than Evolution blades!

Bought this blade to cut up old aluminum gutters. It performed the task and then some. Was pleased with it performance and it made the job easier than I thought it did.

First purchase of a metal circular saw disk. Seemed to work excellent for a while. Then it went dull after a couple dozen cuts.It wasn't till then I noticed my saw was 5600 RPM. This is a low speed blade. Recommended 2000 RPM. Basically requires a special saw or one with adjustable speed. I'm going to install aMy bad. Just a warning

I bought this blade nearly two years ago for a Dewalt saw, and have made hundreds of cuts with it into everything from 2" 11ga square tube to .5x2 steel bar to 1x1 316L stainless bar. I just swapped it out yesterday--it's definitely dull and probably 20 teeth are mostly missing. If I had been using a different saw with abrasive blades, I would have burned through more than a dozen for the same amount of work. These are cheap enough that it's more cost efficient to just replace it instead of replacing teeth and resharpening, so I'm ordering another.

Perfect replacement for the abrasive cut off wheel that comes with the HF cut off saw. Cuts very fast and smooth, and doesn't heat up the metal.

I bought a few of these blades over the past year. They are junk. After 6 cuts they start to slow in cutting and eventually just burn and spark. Buy the Evolution Blades and you will be much more satisfied.

The manufacturer appears to have printed the wrong side of the blade. Will update with performance report.

I have only used to rip deep unistrut down for conduit. Made about 40 cuts in the time it takes to do 10 with abrasive wheel and very little amount of burrs to clean. Will update after I use it more but very happy with it.