Full Face Respirator Mask with Filters: 6800 Gas Mask with 6001 & 2097 Filter Reusable Organic Vapor Mask Against Fumes Gases Dust for Painting Epoxy Resin Welding Construction Emergency Polishing

This mask works great for my different projects. Very easy and simple changing the attachments. I did have to look up how to properly use it in a video because the directions were a little confusing for me. Once I figured it out it was great! I use it all the time for my spray painting, when I'm using my resin, when I'm sanding. I would highly recommend. The first thing I used it for was my spray paint in and I'm not sure if it's just the scent of the spray paint that is stuck on the mask but every time I take the mask off I smell that same smell every time

I recently purchased this to use while cutting and polishing rocks for lapidary use.I'm really happy with it. I purchased another mask that was too small for me that unfortunately, I couldn't return. The nice thing about this mask is that you don't need to have safety glasses, you get the whole thing all in one.The seal is excellent (and I have a short beard - no problem at all. When I do the seal test on it - tight seal.And it's comfortable. I had it on my first time for over 2 hours and was pretty comfortable working in it the whole time.

I have been using it for about two months, i use it almost everyday at work. I did buy some window tint and put that on the inside to help block the sun and that helped a lot. over all this is better then the 3m one that i had that did not have the face cover but had flimsy straps.

It's not bad. I get a good seal and the mask is good but I did have one of the tabs break off the first time I tried to attach a filter. Be careful of that and it should be good

Leaking seals right out of the box. Bought 2 of them for a project and I tested each before use. The seal around my face was good but the check valve seals let air in. One of them has a bad exhaust flapper seal. The other has a bad cheek’s flapper seal. Overall these might be good for non painting/chemical projects. Did a return and they did not accept it but Amazon gave me a refund

I have been using this mask several times a week for 3 or 4 hours a day while working with both woodworking equipment (saws, sanders, blowers etc) and epoxy resin. I really wanted it for resin work because I get itchy when touching and breathing resin fumes. Using this mask, I seem to have eliminated my exposure to the fumes. I do wear Tyvek coveralls and gloves too so I am pretty well protected. I am 6'0" with a fairly large head and this mask has been very comfortable. This respirator mask barely fits me, however, I still have to pull the straps a bit to get a nice tight seal. If I do not, I can smell a little bit of the fumes seeping in. I have been doing DIY work with paints and chemicals for more than 30 years and have always found other respirators to be uncomfortable, but this is my first with an integrated face shield and respirator and have found it to be comfortable where I hardly notice it, even after wearing it for several hours. The visibility through the face shield has been very good and has not fogged up on me. Hope this helps...

Quality seal no fogging

Fit ok. Looks good, but does not keep out paint fumes. I feel for anybody wearing this for a gas attack at the end of the world. Lol